RAV does not lower its quality standards for their entry level machines. From the top to the bottom of our range the quality stays at the same high level. This is one of the reasons that the G7240.22 Standard SwingArm Tire Changer presents such an outstanding value.
It will compare favorably to machines tilt will compare favorably to bestselling competitor models costing thousands of dollars more. This machine is manufactured in our factories in Northern Italy just like all RAV products are. If you are looking for a basic tire changer that can handle high volume…. if your budget is limited but you insist on something that will last…. this is the machine for you.
• Powerful 115 volt single speed drive
• 22″ outside clamping
• 40″ maximum tire diameter
• Pneumatic help device is optional
• Plastic demount heads and conversion kits are available
Options
• PLUS 91N 3 arm pneumatic help
• Wheel lift is optional
• Plastic duckbill kits are optional
Comparable to Hunter’s TCX50 Basic Swing-Arm Tire Changer
Frame engaging rubber padded truck adapters with multiple extensions to raise most vehicles on the road today. Includes four (each) adapter extensions at 3.5″ and 5″. Spot-Rite™ 3-Stage Front Arms to accommodate vehicles both symmetrically and asymmetrically. This feature allows the technician to position the vehicle doors in front of or behind the column to prevent door damage.
Additional Features:
- 10,000 lbs. capacity for raising most passenger cars, trucks and vans.
- The I10 has been third party tested by ETL and approved by ALI.
- 3-stage front arm design enables you to position doors in front of the column or behind to avoid door damage.
- Includes adjustable frame contact adapters.
- Adapter storage bracket kit.
- Hydraulic cylinders in each column:
- Top-mounted | Direct pull lifting technology | Cylinder rod concealed inside the carriage
|
Specifications |
I10N400MBL |
|
Capacity |
10,000lbs |
|
Max. Rise w/5″ extension |
76-1/4″ (1937mm) |
|
Overall Height |
143″ (3632mm) |
|
Overall Width |
131″ or optional 137″ (3327mm / 4380mm) |
|
Drive through clearance |
99″ or optional 105″ (2515mm / 2667mm) |
|
Overhead switch height |
137-5/8″ (3496mm) |
|
Front reach (Min/Max) |
23″ / 44-1/2″ (584mm / 1130mm) |
|
Rear reach (Min/Max) |
36″ / 58″ (914mm / 1473mm) |
|
Min/Max Adapter Height |
3-3/4″ (95mm) no adapter extension |
|
Width Inside Column |
109″ or optional 115″ (2769mm / 2921mm) |
|
Adapter Heights |
3-1/2″and 5″ |
|
Voltage/Amps |
208 / 230, 15 amps; 208/230, 16 amps |
|
Motor |
1ph*/2HP/50Hz; 1ph*/2HP/60Hz |
|
Ceiling height required |
144″ (3658mm) |
|
*3-phase available at additional cost |
|